Octopus 5mm LED Brick OBLED – Red



In stock


Octopus Electronic Bricks, you can use them to build electronics projects just as easily as piling bricks.

By using Octopus electronic bricks, you can connect Arduino/Freaduino compatible boards easily with various digital, analog and I2C/Uart interfaces or you can connect to a micro:bit with the Octopus:bit. These breadboard-less firm connections are ready to be used with extensive modules like potentiometers, sensors, relays, servos and even buttons: just plug and play.

This is the Octopus 5mmLED light Brick. When the LED light module is connected, the digital pin (LOW on, HIGH off) is used to control it. The brightness of LED can be controlled via PWM output.

News: All of the Octopus bricks support Scratch programming. The guide is available here.


  • Voltage: +3.3-5V
  • Pin Definition :1 Signal(Yellow) 2 Vcc(Red) 3 GND(black)
  • Weight: 5g


  • 1 x 5mm LED Brick
  • 1 x Analog Sensor Cable

Please visit the wiki or check out this code sample for more information.